The New Home for the Sheet Metal Industry Forums
SheetMetalTalk
 


Go Back   Sheetmetal Talk > Sheet Metal Forums > Duct Construction and Uses

Duct Construction and Uses
Discussion in fabricating and use of products that move air including spiral pipe, duct board and typical sheet metal work.
       


Share This Forum!  
 
 
     

 

Reply
 
Thread Tools Display Modes
  #1  
Old 01-17-2016, 09:46 AM
tinnerjohn tinnerjohn is offline
Member
 
Join Date: Nov 2004
Location: N.E. Ohio
Posts: 89
Thanks: 35
Thanked 20 Times in 15 Posts
Default Insulating/Sealing duct

In trying to continue to up the quality of my work, I've started paying more attention to tightening up my work. I've been sealing the connections to the furnace with HVAC silicone and taping the joints (s& drive and round pipe). I've been caulking the seams on the boots also. In unconditioned space I double wrap with foil faced bubble wrap (not sure of brand). Am I going overboard or is there something else I could do? I'm a one man shop and not set up to line duct. I use a combination of purchased and handmade w/ pittsburg rect. duct and fittings. so I'm wondering if the seams should be sealed. Looking for thoughts/ideas from those smarter than I . Thanks for any suggestions or input. John
Reply With Quote
  #2  
Old 03-10-2016, 01:12 PM
b.c.tinbasher b.c.tinbasher is offline
Member
 
Join Date: Mar 2011
Location: Central British Columbia
Posts: 76
Thanks: 12
Thanked 9 Times in 6 Posts
Default Seal it!

Always good practice to seal your joints, helps ensure the air gets to where it is supposed to go. Caulking; I assume you mean with a caulking gun, is probably more work than applying duct sealer from a can with a paint brush.
Sealant can hide a few "sins" as well, if artfully applied
We would occasionally use caulking on the small end of round duct connections, so the sealant is hidden, for exposed ducts.

As for insulating, not sure on the high temperature rating of foil covered "bubble wrap" but it is probably a good insulator. Will it last on a hot plenum?
We only ever used foil faced fiberglass duct wrap, 1" or 2" on the outside of ducts (6 of one, half dozen of another?)
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


 

All times are GMT -6. The time now is 11:27 AM.


Powered by vBulletin®
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.