Canadian Red Seal - Page 17

Stickman · #**161** 02-10-2011, 07:47 PM

WOW....this thread is going on 5 yrs. old....might want to start a new one.

Bud · #**162** 02-10-2011, 08:03 PM

Right. I'll figure out something here? How about a forum on Testing For industry and I can break that up into different sub forums?

Stickman · #**163** 02-11-2011, 07:04 AM

Quote:

Originally Posted by Bud

Right. I'll figure out something here? How about a forum on Testing For industry and I can break that up into different sub forums?

Thats sounds like a good idea...definately a popular subject. I have been on some electronics forums where they get so old & long, that if you start at the beginning.....soon you are really confused

and forgot what you were reading about

cactassdupree · #**164** 02-11-2011, 05:01 PM

Quote:

Originally Posted by Bud

Right. I'll figure out something here? How about a forum on Testing For industry and I can break that up into different sub forums?

That's a Great idea, as usual Bud.

dupree

lawrencee · #**165** 02-15-2011, 04:30 PM

hey guys i just posted 30 questions off my exam on the q and a part for the red seal let me know if they help or if you have any questions

johnnyc · #**166** 03-05-2011, 03:50 PM

there is a question on there about a ship ventilator. What layout. the gores are triangulation but i thin the bottom straight piece of pipe would be considered parallel line. I chose paralell and triangulation

johnnyc · #**167** 03-05-2011, 03:57 PM

also that question about minimum distance to a vav. in my area we use 3 x dia. of inlet. but i saw 4x on the test and chose it. I realy wish the government would put some backing behind a code book like SMACNA so we could get this stuff set in stone. Anyone know the correct answer to this question?

b.c.tinbasher · #**168** 03-15-2011, 04:26 AM

I was taught that 4x duct diameter is the rule of thumb. I believe SMACNA recommends this as well.

Apprentice · #**169** 04-02-2011, 03:47 PM

Quote:

Originally Posted by b.c.tinbasher

I was taught that 4x duct diameter is the rule of thumb. I believe SMACNA recommends this as well.

You are correct sir!

Apprentice · #**170** 04-02-2011, 03:55 PM

I'm currently in the Advanced level of schooling. I have all my Hours done and can write the C of Q as soon as I'm done if I want.
I would like to know by experiance should I wait and study a little bit (like a month) or get it over with right after school?