The New Home for the Sheet Metal Industry Forums
SheetMetalTalk
 


Go Back   Sheetmetal Talk > Sheet Metal Forums > Sheet Metal Machinery Talk

Sheet Metal Machinery Talk
Discussion on Metal Fabrication Machinery including Q&A on maintenance and repairs. Plasma, Lock Formers, Brakes, ect.


Share This Forum!  
 
 
     

 

Reply
 
Thread Tools Display Modes
  #1  
Old 05-14-2008, 02:43 PM
Dice Dice is offline
Junior Member
 
Join Date: May 2008
Location: Texas
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
Default How do I adjust blades on shear?

I just found this message board and found lots of good info from your posts. I have a Tennsmith air-powered shear and I've noticed it's starting to "foldover" some of my material if it's sheared too close to an edge of the material. Is there an adjustment or do I need to sharpen the blades or do you have any other ideas?
Reply With Quote
  #2  
Old 05-15-2008, 07:26 AM
Gladwin-Omaha Gladwin-Omaha is offline
Member
 
Join Date: Nov 2006
Location: Omaha, NE
Posts: 57
Thanks: 0
Thanked 6 Times in 6 Posts
Default

Are your blades still sharp? Run the top of your fingernail across the blade edge. Does it peel any of your nail off? If so, then the blades are sharp. If not, then you can flip the blades to a unused sharp side.

It also sounds like your blades are gapped too wide. You need to shim the blades to a .002" gap all along the blade length.

The blade gap adjustment steps are located in your manual.

Chad.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


 

All times are GMT -6. The time now is 01:36 AM.


Powered by vBulletin®
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.