The New Home for the Sheet Metal Industry Forums
SheetMetalTalk
 


Go Back   Sheetmetal Talk > Sheet Metal Forums > Duct Construction and Uses

Duct Construction and Uses
Discussion in fabricating and use of products that move air including spiral pipe, duct board and typical sheet metal work.
       


Share This Forum!  
 
 
     

 

Reply
 
Thread Tools Display Modes
  #1  
Old 08-02-2016, 09:07 PM
The Noob Sheet Metal The Noob Sheet Metal is offline
Junior Member
 
Join Date: Aug 2016
Location: Sacramento, California
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
Red face Help this Newbie in the Field Please

I want to have a better understanding in the sheet metal work. I came into the trade without any experience, actually I don't even know that sheet metal exit until I was introduce to. I am going into my 2nd year apprentice and notice that I didn't get enough experience from the field. I notice that I have a little hard time understanding offset (45 degree, 90 degree) (spiral and square fitting). I want to join the TheSheetMetalShop forums because I was wondering if someone is patience enough to teach me a easier way. A lot of the duct work that we are hanging is expose so I am nervous of my math to get the right fitting. Thank you.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


 

All times are GMT -6. The time now is 01:07 AM.


Powered by vBulletin®
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.