The New Home for the Sheet Metal Industry Forums
SheetMetalTalk
 


Go Back   Sheetmetal Talk > Sheet Metal Forums > Duct Construction and Uses

Duct Construction and Uses
Discussion in fabricating and use of products that move air including spiral pipe, duct board and typical sheet metal work.
       


Share This Forum!  
 
 
     

 

Reply
 
Thread Tools Display Modes
  #1  
Old 09-25-2013, 09:48 PM
ncscribe ncscribe is offline
Member
 
Join Date: Sep 2009
Location: Western Maryland
Posts: 48
Thanks: 8
Thanked 13 Times in 10 Posts
Default Got a little duct work done

Well the BIL called a while back. Was putting a newer furnace in. The old one was a 1958. So I told him I would help. We started yesterday and finished today. We did everything at his place. No real tools (as in shop tools) So it was back to real old school. Plier bent flanges and such. Even made the S cleats by hand. Everything turned out rather well, especially being as rusty as I am. I think the best part was the Pittsburg seams that I did. Some pliers some hammering. It worked and they were surprisingly straight. All in all a good job.
Reply With Quote
  #2  
Old 09-27-2013, 07:20 AM
wmckane wmckane is offline
Professional Member
 
Join Date: Apr 2005
Location: Oxford, PA
Posts: 126
Thanks: 4
Thanked 40 Times in 29 Posts
Default

Good for you!
Reply With Quote
The Following User Says Thank You to wmckane For This Useful Post:
ncscribe (09-29-2013)
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


 

All times are GMT -6. The time now is 08:05 PM.


Powered by vBulletin®
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.