Thread: Square to round
View Single Post
  #13  
Old 02-24-2011, 12:50 PM
mike39 mike39 is offline
Junior Member
 
Join Date: Jan 2011
Location: Calgary,AB
Posts: 27
Thanks: 7
Thanked 0 Times in 0 Posts
Default I get it.

Ok, finally figured it out! Thanks to everyone for all the help. Bud's rectangle to round exercise from this website helped alot, but my biggest problem was I missed something in Bud's square to round lesson on Sheet Metal World......... I wasn't taking my generator line spacing from my top view, leaving me with too much material, and generator lines that weren't always higher than the preceding line.
Pays to pay attention, I guess.

1. Square to round from Sheet Metal World
2. Rectangle to round from Sheet Metal Shop
3. Square to round, flat side, that I couldn't get out of my head!
Attached Thumbnails
20110223_12.jpg   20110224_5.jpg   20110224_4.jpg  
Reply With Quote