View Single Post
  #2  
Old 05-06-2005, 10:58 AM
Bud's Avatar
Bud Bud is offline
ME
 
Join Date: May 2003
Location: Waukesha
Posts: 2,101
Thanks: 416
Thanked 125 Times in 88 Posts
Default

I have one and it leaves a small burr as well...nothing too bad or anything to worry about, the next process, depending on what you're doing isn't affected by it. As for the the indent where the pin sets down as it is clamped..not much you can do about that...

I'm nut sure about why it's not cutting true, but if it weren't aligned properly and off center, it may dog leg a bit as you go around, the pin or center should be in line (perpendicular) to the tangent point of the cutting wheels.(makes sense to me, how bout anyone else)
Reply With Quote