Sheetmetal Talk

Sheetmetal Talk (http://www.sheetmetaltalk.com/index.php)
-   A Tinners Porch (http://www.sheetmetaltalk.com/forumdisplay.php?f=4)
-   -   Shelves (http://www.sheetmetaltalk.com/showthread.php?t=2726)

Stickman 03-06-2016 08:53 AM

Shelves
 
1 Attachment(s)
Not everyday you have a order to make shelves since they are so cheaply made to buy anymore. One of my best customers wanted them to be just like this, it was a challenge to assemble it keeping everything square and inline. The shelves are 84x48x18D and I used 5 4x10 sheets of 24 ga. to do the project. Shelves were a hemmed J-bend on front lip and channel bent on sides and back. The outer shell was also a hemmed reverse J-bend. In other words.....it was a lot of bending :D but you can stack it full of books if you wanted too.

Bud 03-06-2016 10:54 AM

Nice Job.

Rob 03-06-2016 05:51 PM

Looks good.
Single hem on the front of the dividers?
What's holding the dividers in place?

Rob 03-06-2016 06:14 PM

OK, when I enlarge the pic I see the rivet heads.:thumbup1:

ncscribe 04-19-2016 09:45 PM

Nice job!!


All times are GMT -6. The time now is 08:54 AM.

Powered by vBulletin®
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.