Sheetmetal Talk

Sheetmetal Talk (http://www.sheetmetaltalk.com/index.php)
-   Metal Roofs (http://www.sheetmetaltalk.com/forumdisplay.php?f=18)
-   -   Stainless chimney flashing (http://www.sheetmetaltalk.com/showthread.php?t=2506)

lyonsco1 01-21-2014 08:19 PM

Stainless chimney flashing
 
1 Attachment(s)
The other guy had some pretty creative uses for step flashings.

lyonsco1 01-21-2014 08:22 PM

1 Attachment(s)
Sorry for the double post, it wouldn't let me add two pics in the same post

lyonsco1 01-22-2014 03:01 PM

1 Attachment(s)
Cleat soldered to back of pan.

Bestfish 02-03-2014 07:57 AM

Wow, all I can say

Kurtis 06-25-2014 03:30 PM

lyons, how do you burry that curved seam so close to the edge? Are there "tucks" or pockets on the underclock side? or is it a shrink?

lyonsco1 06-30-2014 05:03 PM

3 Attachment(s)
The vertical pieces get a .25" flange and the horizontal pieces get a + .25" hem. Any larger hem than .25" causes a buckle when folding over.
Next time I make one I'll take better pictures.

When cutting the sides you need to make sure it's smooth, any burrs will split where the radius gets tight when you hammer over the flange. The sides are cut to match the slope of the roof and the faces (horizontal pieces) are bent over a 2" pipe to match the radius.

No stretching or shrinking necessary, just a hammer, smooth jaw offset left and right snips and a pair of seaming pliers.


All times are GMT -6. The time now is 12:56 AM.

Powered by vBulletin®
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.