PDA

View Full Version : Damper Hardware


tinnerjohn
04-14-2013, 09:58 AM
Can anyone direct me to a source for damper hardware? Using round take-offs and a Malco circle cutter, the cutout is the right size, but I've used all the hardware I had. Checked with my suppliers, but was met with a blank look. I've been buying pre-made dampers, but I hate to waste (scrap) the cut-out. John

tinnerjohn
04-14-2013, 10:08 AM
Never mind, I think I found what I'm looking for. John

Rob
04-14-2013, 04:09 PM
What did you find?
And where?

tinnerjohn
04-16-2013, 07:48 AM
Iwas looking for hammer-on pivot and handle sets. I found Elgin Manufacturing has/makes them. Sent them a E-mail sun. they answered back Mon. AM with a quote, haven't ordered yet, but will this week. John

Rob
04-16-2013, 03:35 PM
I haven't used those in years.
Thanks for reminding me about them.
For anyone that's interested, Duro Dyne has them also.

http://www.durodynecanada.ca/canada/products/hardware/regulators/rapit_sheet.pdf

wmckane
04-17-2013, 06:05 AM
Another source is Cain Manufacturing (no relation!), who have all types plus turn vane, access doors, and more. www.cainmfg.com