PDA

View Full Version : Question?


dawg20
08-07-2010, 06:24 AM
I am running 6" pipe.Offsetting both ways,the horizontal offset is 7".The vertical offset is yet to be determined (have'nt got that far yet).I am tapping out of the bottom of duct with a 12"L stodd.Foreman gave me 2 90* degree gore elbows and 1 30* degree gore elbow to use.How do i go about this? Thank's! for your help!

Bud
08-07-2010, 06:43 AM
Welcome to the site!

I am tapping out of the bottom of duct with a 12"L stodd.

I'm not sure what you mean here? Can you elabroate a bit more? I'll check back a bit later to help you out.

Bud
08-07-2010, 08:46 AM
Checked back?

dawg20
08-07-2010, 04:49 PM
It's basically a square to round cut into the side/bottom of a duct run.Similiar to this pic http://www.audubonsupply.com/prodimg/63.jpg also known as a takeoff.Usually with a damper,standard height is 12".

Rob
08-07-2010, 05:21 PM
Hi dawg20.
Link won't open for me.
Anyway, if it's a standard side take off, you should only need the two 6"x90 elbows (depending on the height).
Turn and adjust the gores as needed.

Bud
08-08-2010, 07:15 AM
I fixed the link above. One to many http:// in it.

If they are adjustable gore elbows, you can make just about any offset.